3x WEBER 40 IDA 3C main venturi choke tube 30mm 32mm 34mm 36mm 38mm$ 88.4 ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › Part number: 71502Made in: EUCompatible with:Family: WEBER40 IDA 3C (3 pcs)Family: IDA40 IDA 3C - pn: 34894.002 (3 pcs)40 IDA 3C-3C-1 - pn: 34894.002 (3 pcs)Family: IDL40 IDL 3C1-2-3 - pn: 34894.002 (3 pcs)Family: IF40 IF 3C1-2-3-4 - pn: 34894.002 (3 pcs)3x Weber 40 IDA 3C Main Venturi Choke Tubes – 30mm to 38mm These main venturi, also called choke tubes, are used in Weber 40 IDA 3C carburetors to control the air passage through the carburetor throat and establish the pressure signal that supports fuel draw from the main circuit. Their bore size affects air velocity, main-circuit response, progression into the main system, and the engine’s airflow capacity at higher demand. Venturi bore selection is a key part of Weber IDA calibration. A smaller tube can increase air velocity and strengthen the metering signal, while a larger tube can support greater airflow with a different response characteristic. Final selection should match the engine, camshaft, displacement, operating range, and overall carburetor calibration. These tubes are suitable for service, recalibration, or replacement of worn or damaged venturis in Weber 40 IDA 3C carburetors. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: 71502. What Is Included Set of 3 main venturi/choke tubes for Weber 40 IDA 3C carburetorsAvailable bore sizes: 30 mm, 32 mm, 34 mm, 36 mm, or 38 mmMade in EU. Important Fitment Note Confirm that the carburetor is a Weber 40 IDA 3C and verify the required venturi bore before purchase. Check the marking or code on the existing carburetor and compare the replacement with the removed tube for bore size, outside geometry, seating position, retaining arrangement, and the relevant thread or interface details where applicable. Venturi dimensions and retention features can vary between carburetor families and configurations. Compare the selected size and physical interface with the removed venturi before installation. The selected bore should also suit the engine’s airflow requirements and intended operating range; venturi size alone does not establish the complete fuel calibration.What you see is what you getShow all parts