BLUE Velocity Stacks Air horns trumpets WEBER 40 DCOE IDF DELLORTO DHLA 25mm
$ 63.4
Part number: ST3816
Made in: EU
BLUE Velocity Stacks Air Horns for Weber 40 DCOE / IDF, Dellorto DHLA and Solex 40 ADDHE
These blue velocity stacks, also called air horns or trumpets, mount at the carburetor air inlets to provide a smoother entry path into the carburetor throat. They help control airflow entering the inlet and can influence intake response and air-entry behavior, particularly where the carburetor operates with exposed intake mouths.
Two 25 mm blue anodized air horns are included. Each air horn has a stated 25 mm total length and 40 mm internal diameter. The bolt-on design is intended for compatible 40-series carburetor applications, including Weber 40 DCOE, Weber 40 IDF, Dellorto 40 DHLA and Solex 40 ADDHE configurations.
These are intake-side components, not fuel-metering parts. They do not replace main jets, emulsion tubes, idle jets or fuel-level controls; carburetor calibration remains dependent on the complete induction setup and engine requirements. The air horns are made from aluminium alloy and finished in anodized blue. MPN: ST3816x2.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: ST3816x2.
Technical role: Intake-side blue anodized velocity stacks for compatible Weber 40 DCOE/IDF, Dellorto 40 DHLA, and Solex 40 ADDHE carburetors.
Service relevance: Provides a smoother entry path at the carburetor mouths without replacing fuel-metering components such as jets or emulsion tubes.
What Is Included
- Two blue anodized aluminium-alloy air horns / velocity stacks
- Each air horn has a 25 mm total length and 40 mm internal diameter
- Made in EU.
Important Fitment Note
Verify the carburetor family and exact body code before purchase. These air horns are intended for compatible Weber 40 DCOE, Weber 40 IDF, Dellorto 40 DHLA and Solex 40 ADDHE applications, but carburetor variants can use different inlet interfaces.
Check the mounting geometry, bolt-hole pattern, throat alignment, inlet diameter, and available clearance inside the airbox or filter assembly. Compare the 40 mm internal diameter and bolt-on interface with the removed air horn or the carburetor inlet before ordering.
Confirm the code marking, interface geometry and mounting pattern against your carburetor before installation.
What you see is what you get
Show all parts