THROTTLE LEVERS PAIR LINKAGE for WEBER DCOE CARBURETOR made in CN$ 44.2 ‹ › ‹ › ‹ › ‹ › Part number: ST4338Manufacturer: FAJSIncludes:THROTTLE LEVERS PAIR LINKAGE for WEBER DCOE CARBURETOR This ST4338 throttle lever linkage is a left-and-right lever pair for Weber DCOE carburetors. The levers transfer external throttle-linkage movement to the carburetor throttle shaft, controlling synchronized throttle-plate opening during idle transition, progression, acceleration, and full-load operation. Pair includes one left lever and one right lever. Correct lever geometry is important for matching throttle travel, linkage alignment, and return-spring operation. A worn, bent, loose, or incorrectly positioned lever can contribute to uneven barrel opening, poor synchronization, inconsistent transient response, or failure of the throttle plates to return correctly. This component operates the throttle mechanism; it does not calibrate the main circuit, emulsion system, enrichment circuit, or fuel-level control. The levers have a yellow-zinc finish and are identified by MPN ST4338. Verify the lever interface and linkage arrangement before installation, particularly when replacing only one side of an existing Weber DCOE setup. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST4338. Technical role: Left-and-right throttle lever pair that transfers external linkage movement to the Weber DCOE throttle shaft for synchronized plate opening. Service relevance: Replacement is relevant for worn, bent, loose, or misaligned levers causing uneven opening, inconsistent response, or improper throttle-plate return. What Is Included One left throttle lever for Weber DCOE carburetor linkageOne right throttle lever for Weber DCOE carburetor linkage Important Fitment Note Verify that the carburetor family is Weber DCOE and compare the ST4338 lever geometry with the removed parts. Check the throttle-shaft interface, lever offset, mounting-hole position, fastener or thread arrangement, and return-spring attachment points before purchase. Also confirm that the left/right orientation matches the existing linkage and that the installed levers allow the throttle plates to reach idle and full-open positions without binding. Compare the removed levers directly before installation; DCOE linkage geometry can vary between applications and assemblies.What you see is what you getShow all parts