Jetting Kit Weber 40/42/45/48/50 DCOE/IDF main jet air corrector 60 jets custom$ 250.8 ‹ › ‹ › ‹ › ‹ › Part number: ST4223Made in: EUIncludes:Custom 60-Jet Weber DCOE/IDF Jetting Kit – Main Jets and Air Correctors This custom jetting kit provides a selection of main jets and air correctors for calibration work on Weber 38/40/42/45/48/50/55 DCOE and Weber 36/40/44/48 IDF carburetors. 60 jets are included in the custom selection. Choose the required combination and sizes of main jets and air correctors for your tuning specification. Main jets meter fuel through the carburetor’s main circuit as airflow and engine load increase. Air correctors influence the fuel curve at higher engine speed by controlling the air bleed effect in the emulsion system. Correct selection helps address rich or lean mixture behavior, poor high-rpm response, and calibration changes caused by engine modifications, intake configuration, exhaust changes, or altitude. The kit is intended for service and tuning rather than automatic vehicle-specific fitment. Jet selection should be based on the carburetor model, engine requirements, existing calibration, and measured running behavior. A jetting table is available on request. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST4223. Technical role: Provides a custom selection of 60 main jets and air correctors for Weber DCOE and IDF carburetor calibration. Service relevance: Supports adjustment of main-circuit fueling and higher-rpm air-correction behavior during carburetor tuning. What Is Included Custom selection of 60 Weber main jets and air correctorsMade in EU. Important Fitment Note Verify the carburetor family and model before ordering, including whether the application uses Weber DCOE or IDF carburetors and the specific model code. Confirm the marking and size of each removed jet, then compare the replacement jet’s body geometry, thread/interface, and seat style with the original part. Also verify whether your calibration requires main jets, air correctors, or a combination of both. Compare the selected jet markings and physical interface with the removed parts before installation. Jet sizes should be chosen as part of the complete carburetor calibration; a correct-looking jet is not automatically correct for every Weber application listed.What you see is what you getShow all parts