FAJS CHOKE TUBE size 46 for Weber 48/50/55 DCO/SP
$ 11.6
Part number: ST4141
Manufacturer: FAJS
FAJS Choke Tube Size 46 for Weber 48/50/55 DCO/SP
This FAJS size 46 choke tube is the venturi component used inside compatible Weber and FAJS 48/50/55 DCO/SP carburetors. It controls the primary airflow restriction and fuel-signal strength through the main circuit, influencing air velocity, emulsion draw, progression, and transient response. A different choke-tube size can change the carburetor’s calibration requirements, so the installed tube should be matched to the intended setup.
Size 46 choke tube for Weber/FAJS DCO/SP carburetors. The tube is marked 46 and carries the FAJS manufacturer identification. It is a service and tuning component rather than a fuel-level-control or jet component; correct selection is important when restoring carburetor calibration or replacing a damaged or missing venturi tube.
This item was removed from an unused new FAJS carburetor. It is a FAJS sale item rather than part of the standard offer, and its quality corresponds to FAJS parts.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: ST4141.
What Is Included
- One FAJS size 46 choke tube
Important Fitment Note
Verify the carburetor family and model marking before purchase: Weber or FAJS 48/50/55 DCO/SP. Confirm the size marking “46” against the removed choke tube and check that the tube’s internal geometry, outside seating profile, retaining features, and installation interface match the original part. If the carburetor uses a specific thread, shoulder, tab, or seat arrangement, compare that interface directly before installation.
Compare the removed part with the size 46 marking, venturi geometry, seating surfaces, and retention method; model-family similarity alone does not confirm fitment.Show all parts