MAIN JET M5 size 135 for SOLEX, KEIHIN, MIKUNI, EMPI, VW Beetle
$ 5
Part number: ST1870
Made in: EU
MAIN JET M5 Size 135 for Solex, Keihin, Mikuni, EMPI and VW Beetle
Size 135 with M5 thread The jet can be used when servicing a carburetor, correcting main-circuit mixture after engine or intake changes, or replacing a damaged, contaminated or incorrectly sized jet. A main jet that is blocked, worn or mismatched can contribute to poor high-load running, hesitation during sustained acceleration or an excessively rich or lean mixture. Correct calibration also depends on the carburetor family, air-correction system, emulsion arrangement, fuel level and engine specification.
Other main jet sizes, including 120, 130 and 140, are available separately for calibration work. Verify the required size from the carburetor specification and the engine’s current setup rather than selecting by thread size alone.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: ST1870.
Technical role: M5-thread main jet, size 135, for metering the main fuel circuit in compatible Solex, Keihin, Mikuni, EMPI and VW Beetle carburetors.
Service relevance: Used to replace a blocked, worn or damaged main jet or recalibrate mixture after engine or intake changes.
What Is Included
- One M5 main jet, size 135, MPN ST1870
- Made in EU.
Important Fitment Note
Confirm the carburetor family and any code or marking before ordering. Check that the replacement uses the same M5 thread, body geometry, seating arrangement and fuel-passage interface as the removed jet. Compare the new part directly with the original for threaded engagement, shoulder or seating position, visible metering-end configuration and overall installation depth.
Verify the existing jet and carburetor specification before installation; M5 thread alone does not confirm complete fitment or calibration suitability.
What you see is what you get
Show all parts