Trumpet 50mm 2" Weber 40 DCOE slide in Velocity Stack ALLOY air horn ram pipe$ 32.3 ‹ › ‹ › Part number: ST3752Made in: EUIncludes:Trumpet 50mm 2" Weber 40 DCOE Slide-In Velocity Stack Alloy Air Horn – MPN AH4040 This alloy air horn is a slide-in velocity stack for the inlet of a Weber 40 DCOE carburetor. It provides a smoother, more controlled transition into the carburetor’s main air entry than an exposed sharp inlet edge, supporting consistent airflow into the air corrector and main-circuit area. The visible air horn length is 50mm (2 inches) and should be considered when checking bonnet, filter, ram-trumpet, and surrounding engine-bay clearance. Inlet trumpet length and shape can influence entry losses, airflow signal, induction noise, and transient response, so the final carburetor calibration should be evaluated with the complete intake arrangement installed. This part is an air-entry component; it does not replace jets, emulsion tubes, or other fuel-metering parts. The slide-in mounting arrangement uses the supplied tabs, lock washers, and nuts to secure the trumpet to the carburetor inlet assembly. The alloy surface can be polished to a mirror finish using a cotton wheel. Mirror polishing is not completed on this item. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: AH4040. What Is Included One alloy air horn / velocity stack for Weber 40 DCOEMounting tabsLock washersNutsMade in EU. Important Fitment Note Verify that your carburetor is a Weber 40 DCOE and compare the AH4040 marking, slide-in interface, trumpet geometry, and available clearance with the removed part before purchase. Check the mounting tab position and the supplied nut-and-washer arrangement against the carburetor body, including the securing interface and any thread engagement required. The 50mm (2-inch) visible length must also be suitable for the surrounding intake hardware and engine-bay space. Compare the inlet profile and mounting arrangement directly with your existing air horn before fitting.What you see is what you getShow all parts