Weber Carburetor Throttle Lever Rod Arm 40/45 DCOE, 40/44/48 IDF linkage$ 19.8 ‹ › ‹ › ‹ › ‹ › ‹ › Part number: ST2333Made in: EUIncludes:Weber Carburetor Throttle Lever Rod Arm 40/45 DCOE, 40/44/48 IDF Linkage Throttle lever with ball-joint connection for external throttle linkage on Weber 40/45 DCOE and 40/44/48 IDF carburetors. The lever transfers movement from the throttle rod or linkage assembly to the carburetor throttle shaft, supporting coordinated throttle opening and accurate response through the progression into the main circuit. Includes an integrated ball-joint linkage connection. The lever is relevant when a worn, damaged, or incorrectly positioned linkage arm causes excessive play, delayed throttle movement, uneven opening between carburetors, or difficulty synchronizing a multi-carburetor setup. Correct lever geometry and orientation are important for maintaining the intended linkage travel and avoiding throttle interference at closed and wide-open positions. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST2333. Technical role: Throttle lever rod arm with integrated ball-joint connection for transferring external linkage movement to Weber 40/45 DCOE and 40/44/48 IDF throttle shafts. Service relevance: Relevant for worn or damaged linkage arms causing play, delayed throttle movement, uneven carburetor opening, or difficult synchronization. What Is Included Throttle lever rod arm with ball jointMade in EU. Important Fitment Note Verify the carburetor family and body identification before ordering: Weber 40/45 DCOE or Weber 40/44/48 IDF applications are the identified references for this part. Check the MPN or marking ST2333 where applicable, then compare the lever with the removed component. Compare the complete interface before installation; visual similarity alone does not confirm fitment. Confirm the lever’s mounting geometry, throttle-shaft interface and seat style, ball-joint position, lever orientation, and any threaded rod or linkage connection. For possible use on other Weber or Dellorto carburetors, verify the shaft arrangement and available clearance through the full throttle range. A mismatch in geometry can alter throttle travel, synchronization, or closed-throttle return even when the lever appears similar.What you see is what you getShow all parts