3x Weber 40 DCOE Gasket kit set repair or rebuild$ 31.2 ‹ › ‹ › ‹ › ‹ › ‹ › Part number: ST3380Made in: EUIncludes:3x Weber 40 DCOE Gasket Kit Set Repair or Rebuild This gasket kit set is intended for servicing a triple-carburetor installation using Weber 40 DCOE carburetors. The gaskets and sealing components support correct sealing between carburetor sections, covers, plates, and related interfaces during repair or rebuild work. Reliable sealing helps prevent unwanted air entry and fuel leakage that can affect idle quality, progression, fuel-level control, and transient response. One set serves three Weber 40 DCOE carburetors. Replace hardened, compressed, damaged, or disturbed gaskets during disassembly so the carburetor can be returned to service without relying on old sealing material. This is a sealing-service kit; it does not replace jets, emulsion tubes, or other calibration components in the main circuit or enrichment circuits. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: 3xii301365083759. Technical role: A gasket and sealing kit for servicing or rebuilding three Weber 40 DCOE carburetors. Service relevance: It replaces disturbed, hardened, compressed, or damaged sealing components during repair or rebuild to support proper sealing at carburetor interfaces. What Is Included Gasket kit set for three Weber 40 DCOE carburetorsMade in EU. Important Fitment Note Confirm that the carburetors are Weber 40 DCOE units and compare the required gasket shapes with the removed parts before disassembly. Check the carburetor code or marking, mounting-hole pattern, passage openings, cover and plate geometry, and any applicable thread, seat, or interface style. A triple-carburetor setup may contain different service configurations, so matching the gasket layout to the existing components is important. Compare the old gaskets and sealing pieces with the kit before installation, and verify that every opening and mounting position aligns correctly. Clean the mating surfaces carefully, remove remnants of old gasket material, and inspect the associated components for distortion or damage before rebuilding.What you see is what you getShow all parts
