4pcs Throttle plate Screw rounded flat head shaft late Weber 38/40/42/45/48 DCOE$ 11.4 ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › Part number: ST3971Made in: EUIncludes:4pcs Throttle Plate Screws for Late Weber 38/40/42/45/48 DCOE Carburetors These throttle plate screws secure the butterfly plate to the throttle shaft inside the Weber DCOE carburetor. Correct screw geometry is important at this interface because the fastener must hold the plate securely without interfering with throttle-bore clearance or shaft movement. A loose, incorrect, or poorly retained screw can contribute to throttle plate movement, air leakage, sticking, unstable idle, or inconsistent transient response. The rounded small head is intended to reduce airflow disturbance around the throttle plate and shaft. The deep slot supports controlled screwdriver engagement during service, while the rear locking hole provides a method for thread locking after final adjustment. MPN 64520.027. The screws are intended for competition and racing carburetor service on Weber 38, 40, 42, 45, and 48 DCOE applications, with fitment dependent on the specific late-shaft configuration. Stainless steel construction provides the specified fastener material, and the yellow chromate layer gives the screw its visible finish. These are mechanical throttle-plate fasteners, not fuel-metering components, so they do not alter the main circuit, emulsion, enrichment, or fuel level calibration directly. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: 64520.027. What Is Included Four throttle plate screws, MPN 64520.027Made in EU. Important Fitment Note Verify that the carburetor family is a Weber DCOE and that the application matches the late-shaft version used with 38, 40, 42, 45, or 48 DCOE assemblies. Check the code or marking on the carburetor and compare the screw head shape, slot style, threaded section, seating geometry, overall interface, and rear locking-hole arrangement with the removed screw. Confirm that the head clears the throttle bore and that the screw engages the shaft and plate correctly before final tightening and thread locking. Compare one removed screw directly with this part before installation; DCOE variants can differ in throttle-shaft and plate hardware.What you see is what you getShow all parts