Cable bracket holder WEBER 32/36 DGV DGAV DGEV 38 DGES
$ 21.3
Part number: ST3034
Made in: EU
Cable Bracket Holder Weber 32/36 DGV DGAV DGEV 38 DGES - ST3034
This cable bracket holder supports and locates the throttle cable at the carburetor linkage on Weber 32/36 DG* and 38 DG* series applications. It keeps the cable housing aligned while the inner cable operates the throttle mechanism, helping maintain consistent cable travel and proper linkage movement. A damaged, missing, or incorrectly positioned bracket can contribute to cable binding, incomplete throttle opening, or poor return movement.
The mounting holes measure 46 mm center to center, approximately 1 3/4 inches. MPN ST3034 Verify the bracket position and mounting interface against the carburetor and removed part before installation, particularly where different linkage or cable arrangements have been used.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: ST3034.
Technical role: Holds and aligns the throttle cable housing at the Weber carburetor linkage.
Service relevance: A damaged or missing holder can contribute to cable binding, incomplete throttle opening, or poor return movement.
What Is Included
- One cable bracket holder, MPN ST3034
- Made in EU.
Important Fitment Note
Verify the carburetor family and model marking, including Weber 32/36 DGV, DGAV, DGEV or 38 DGES/DG* identification. Compare the bracket’s 46 mm center-to-center mounting-hole spacing, overall geometry, cable guide position, and mounting interface with the original part. Check the fastener arrangement and any thread or seating requirements used by the installation.
Compare the replacement directly with the removed bracket before fitting; linkage and cable interfaces can vary between otherwise similar carburetor applications.
What you see is what you get
Show all parts
