Carburetor AIR FILTER 65mm cleaner element Weber DCOE,Solex,Dellorto DHLA
$ 25.1
Part number: ST2228
Manufacturer: FAJS
Carburetor Air Filter 65 mm Cleaner Element Weber DCOE, Solex, Dellorto DHLA – ST2228
This washable cotton air filter insert is designed for use over individual performance carburetor air inlets, helping prevent airborne dirt from entering the carburetor and engine. Clean inlet air supports consistent operation of the main circuit, progression system, and transient throttle response by reducing contamination around the carburetor throat and fuel-metering passages.
The element is intended as a replacement for KN filter applications and is suitable for listed Weber, Solex, and Dellorto carburetor families. Supported Weber applications include 40/45 DCOE, 40/44/48 IDF, and DCNF carburetors. It may also be used with Solex ADDHE and Dellorto DHLA applications when the filter interface and available clearance match.
65 mm filter height must be checked against the available space inside the airbox or around the carburetor intake. A serviceable filter element is important where dust contamination, restricted airflow, or a damaged existing filter could affect mixture consistency and engine protection. The cotton element is washable, allowing cleaning and reuse according to the applicable filter-service practice.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: ST2228.
Technical role: Washable cotton air-filter insert for individual carburetor air inlets, listed for Weber DCOE, IDF, DCNF, Solex ADDHE, and Dellorto DHLA applications.
Service relevance: Provides replacement filtration where the existing element is dirty or damaged, with a reusable design for applicable cleaning procedures.
What Is Included
- One washable cotton air filter insert element, 65 mm tall
Important Fitment Note
Verify the carburetor family and the exact body code or marking before purchase. Check the element’s 65 mm height, round intake geometry, outer and inner seating surfaces, and the retaining or filter-holder interface against the removed filter. Where the application uses a clamp, flange, thread, or dedicated seat, confirm that the replacement element matches that arrangement; no retaining hardware is included unless specifically listed.
The element is associated with Weber 40/45 DCOE, 40/44/48 IDF, and DCNF carburetors, with possible use on Solex ADDHE and Dellorto DHLA units. Compare the new element directly with the removed filter for diameter, seat profile, clearance, and retention before installation.
What you see is what you get
Show all parts