Carburetor socks AIR FILTER 100mm 4" RAMAIR foam Weber DCOE Solex Dellorto DHLA$ 22.9 ‹ › ‹ › ‹ › Part number: ST2599Carburetor Socks AIR FILTER 100mm 4" RAMAIR Foam Weber DCOE Solex Dellorto DHLA This RAMAIR foam sock-style air filter fits over a carburetor air horn to protect the intake from airborne debris while allowing the carburetor to draw filtered air. It is used on performance carburetor installations where individual throttle or air-horn inlets require compact filtration rather than a shared airbox. [ B:]Designed for installation over fitted air horns; an air horn must be installed for this filter to mount correctly.[/B] The filter measures 100 mm (4 inches) in height, with a listed outer diameter of 90 mm (3 1/2 inches) and internal diameter of 60 mm (2 1/2 inches). Its compact form suits multiple-carburetor layouts, including Weber DCOE, DCO, IDA, and IDF applications. The filter does not alter fuel metering, emulsion, progression, or enrichment calibration, but the inlet filter and air-horn arrangement can influence available airflow and transient response, so clearance and intake geometry should be checked during carburetor setup. Listed applications include Weber 38/40/42/45/48 DCOE, Weber 48/50/55 DCO, Weber 40/46/48 IDA, and Weber 40/44/48 IDF carburetors. It may also be suitable for Solex ADDHE and Dellorto DHLA/DRLA carburetors when the air-horn interface and dimensions match. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST2599. Technical role: RAMAIR foam sock-style air filter fitted over a carburetor air horn to filter intake air in compact multi-carburetor installations. Service relevance: It does not alter fuel metering, but its airflow and air-horn arrangement can affect intake clearance and transient response. What Is Included One RAMAIR foam sock-style air filter Important Fitment Note Verify the carburetor family and exact model code before ordering, then compare the filter’s 100 mm height, 90 mm listed outer diameter, and 60 mm listed internal diameter with the available clearance and the installed air horn. Check the air-horn outside geometry and filter interface carefully; this filter requires an air horn and is not a direct replacement for every carburetor inlet or threaded air-filter assembly. Compare it with the removed filter or measure the existing air-horn connection to confirm the fit. Confirm the code marking, inlet geometry, seat/interface style, and clearance before installation.What you see is what you getShow all parts