Dellorto 40/45 DHLA Choke actuator lever
$ 6.1
Part number: 7341
Made in: EU
Dellorto 40/45 DHLA Choke Actuator Lever MPN 7341
This choke actuator lever is used in the cold-start control mechanism of Dellorto DHLA carburetors in the 40/45 DHLA family. It transfers movement from the external choke or starter control to the carburetor’s enrichment mechanism, allowing the cold-start circuit to be engaged and released during operation.
MPN 7341 identifies the lever for comparison with the original part. A bent, worn, or incorrectly shaped actuator lever can limit control travel, prevent full enrichment engagement, or leave the cold-start mechanism partially active. This can contribute to difficult starting, poor cold-running response, or an elevated idle after warm-up. Inspect the lever interface, pivot position, locating features, and linkage contact points during service.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: 7341.
What Is Included
- Dellorto 40/45 DHLA choke actuator lever, MPN 7341
- Made in EU.
Important Fitment Note
Verify that the carburetor is a Dellorto DHLA unit in the 40/45 family and compare the original part marking, if present, with MPN 7341. Check the lever’s overall geometry, pivot-hole position, locating tabs or slots, linkage contact point, and stop orientation against the removed lever. Where the assembly uses an associated threaded fastener, spacer, or seat/interface, confirm that arrangement before installation.
Compare the replacement directly with the removed lever before fitting; DHLA control components can vary by carburetor specification and linkage arrangement.
What you see is what you get
Show all parts
