Dellorto DRLA Choke blanking plate including screws$ 10.7 ‹ › ‹ › ‹ › ‹ › ‹ › Part number: ST3726Made in: EUIncludes:Dellorto DRLA Choke Blanking Plate Including Screws – ECP04 This choke blanking plate is used on Dellorto DRLA carburetors when the cold-start enrichment assembly is removed or no longer required. It covers the unused choke mounting area, helping keep the carburetor body closed and protected during normal operation. The DRLA choke system provides additional fuel during cold starting. Once that enrichment hardware is deleted, the opening must be properly blanked rather than left exposed. For Dellorto DRLA carburetors this plate provides the dedicated cover for that service configuration, with the supplied screws securing it to the carburetor body. It is relevant during carburetor refurbishment, choke removal, and conversion to a manually managed or warm-engine starting routine. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ECP04. Technical role: Covers the unused choke mounting area on Dellorto DRLA carburetors after removal of the cold-start enrichment assembly, using the included screws. Service relevance: Useful for DRLA refurbishment or choke deletion to close the former choke opening during normal operation. What Is Included Dellorto DRLA choke blanking plateMounting screwsMade in EU. Important Fitment Note Verify that the carburetor is a Dellorto DRLA and compare the ECP04 plate with the removed choke assembly or existing blanking cover before installation. Check the plate outline, mounting-hole spacing, screw interface, and the mating surface around the choke opening. The carburetor body should have the corresponding DRLA choke mounting geometry, with no interference from linkage, covers, or adjacent components. Confirm the code marking and mounting geometry against your original part before ordering.What you see is what you getShow all parts
