Drill set 105-200 jet calibration cleaning weber solex dellorto carburetors$ 41.2 ‹ › ‹ › ‹ › ‹ › Part number: JDK05Made in: EUIncludes:JDK05 Jet Drill Set, 1.05–2.00 mm for Weber, Solex and Dellorto Carburetors The JDK05 jet drill set provides stepped drill sizes for cleaning, checking, calibrating, or carefully enlarging carburetor jet orifices. The range covers 1.05 mm through 2.00 mm in 0.05 mm increments, corresponding to jet sizes 105 through 200. Use small diameter steps when enlarging a jet. Remove material gradually, keep the drill aligned with the existing passage, and verify the final opening with the required calibration method. Enlarging a jet is a permanent modification, so compare the original part and target size before machining. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: JDK05. What Is Included JDK05 jet drill setDrill sizes from 1.05 mm to 2.00 mm in 0.05 mm incrementsSizes corresponding to jet markings 105, 110, 115, 120, 125, 130, 135, 140, 145, 150, 155, 160, 165, 170, 175, 180, 185, 190, 195 and 200Made in EU. Important Fitment Note Verify that the drill diameter matches the jet orifice and the calibration objective before use. Confirm the carburetor family and jet type, then check the jet’s code or marking, passage geometry, access angle, and interface details such as thread, seat, or holder style where applicable. Compare the replacement or modified jet directly with the removed part before drilling. Verify the target diameter carefully; enlarging a jet cannot be reversed by cleaning. These drills are intended for jet passage service and calibration. They do not replace verification of fuel level control, emulsion-tube configuration, air correction, or other circuit components that also affect carburetor mixture behavior.What you see is what you getShow all parts