Jetting Kit Weber DCOE IDF 6x Main 130,135,140,145,150 air 170,180,190,200,210$ 235.6 ‹ › ‹ › ‹ › ‹ › Part number: ST4220Made in: EUIncludes:Jetting Kit Weber DCOE IDF 6x Main 130, 135, 140, 145, 150; Air 170, 180, 190, 200, 210 This jetting kit provides a range of main and air-correction jets for tuning Weber 40/45 DCOE and Weber 40/44/48 IDF carburetors. The main jets meter fuel through the carburetor’s main circuit as airflow and engine load increase, while the air jets influence air correction and mixture progression at higher engine speed. Changing these circuits can help address rich or lean mixture symptoms during acceleration, sustained load, and upper-rpm operation when used with correct fuel level, emulsion tube, and engine specifications. 60 jets total are included: five main-jet sizes and five air-jet sizes, with six of each size. Main jet sizes are 130, 135, 140, 145, and 150. Air jet sizes are 170, 180, 190, 200, and 210. This selection allows controlled step-by-step calibration rather than relying on a single fixed jet combination. Always tune in conjunction with the carburetor’s progression circuit, emulsion system, fuel level, ignition condition, and engine configuration. Use the supplied jetting range as a starting point and refer to the applicable jetting table when selecting a combination. A custom jet set is also available here: www.ebay.com/itm/305008371893 This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST4220. What Is Included 30 main jets: six each in sizes 130, 135, 140, 145, and 15030 air jets: six each in sizes 170, 180, 190, 200, and 210Made in EU. Important Fitment Note Verify the carburetor family and exact version before installation: Weber 40/45 DCOE or Weber 40/44/48 IDF. Check the size marking on each replacement jet and compare the thread, seating interface, shoulder or collar geometry, and overall profile with the removed jet. Confirm that the replacement uses the same location and circuit type; a main jet and an air-correction jet are not interchangeable. Compare every jet with the removed part before fitting, especially when carburetor variants or aftermarket components are involved.What you see is what you getShow all parts