MALPASSI FILTER KING Fuel Pressure Regulator carburetor genuine ITALY 6/8mm
$ 108
Part number: FPR_6/8
Made in: Italy
MALPASSI FILTER KING Fuel Pressure Regulator for Carburetors, 6/8 mm, MPN FPR_6/8
The Malpassi Filter King is a fuel pressure regulator for carbureted fuel systems using Weber, Dellorto, or Solex carburetors and Facet fuel pumps. Installed in the fuel supply line between the pump and carburetor, it controls the pressure reaching the carburetor’s fuel inlet and supports stable float-bowl fuel level control.
For Weber, Dellorto, Solex carburetors and Facet pumps
Correct fuel pressure is important to the carburetor’s main circuit, progression, and transient response. Excessive pressure can overcome the needle-and-seat assembly and contribute to flooding, fuel-level rise, or an overly rich condition. Insufficient or unstable pressure can cause fuel starvation, hesitation, or loss of power under load. The 6/8 mm designation should be matched to the vehicle’s fuel-line and connection arrangement before installation.
The MPN is FPR_6/8. Use the regulator as a service replacement where the existing fuel-pressure control assembly, line interface, and mounting arrangement match.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: FPR_6/8.
Technical role: Fuel pressure regulator installed between a Facet pump and Weber, Dellorto, or Solex carburetor to control fuel pressure at the carburetor inlet.
Service relevance: Suitable as a service replacement when the existing regulator, fuel-line arrangement, and mounting setup match, helping support stable float-bowl fuel level control.
What Is Included
- Malpassi Filter King fuel pressure regulator, MPN FPR_6/8
- Visible mounting plate and hardware shown with the regulator
- Made in Italy.
Important Fitment Note
Verify the carburetor family and fuel-pump application before purchase: Weber, Dellorto, or Solex carburetor with a Facet pump installation. Confirm the FPR_6/8 marking and compare the regulator’s 6/8 mm fuel-line interfaces, connection geometry, mounting arrangement, and seat or thread style with the removed part. Check that the available fuel hose and fittings match the regulator without forcing, adapting, or misaligning the connection.
Compare the removed regulator and all fuel-line interfaces before installation; 6/8 mm alone does not confirm complete system fitment.
What you see is what you get
Show all parts