NEW 32/36 DFEV oem carburetor with automatic choke - replace Weber/EMPI/Holley
$ 301.9
Part number: ST2371
Manufacturer: FAJS
NEW 32/36 DFEV Carburetor with Automatic Choke - Weber, EMPI and Holley Replacement
This 32/36 DFEV carburetor is an automatic-choke replacement unit for applications using Weber, EMPI, or Holley carburetors. It meters fuel through the idle, progression, and main circuits, while the automatic choke provides cold-start enrichment before normal operating temperature is reached. Correct calibration of these circuits affects idle quality, throttle transition, part-load response, and wide-open-throttle fueling.
The supplied calibration uses an F50 emulsion tube, 140/140 main jets, 170/180 air correctors, and 60/50 idle jets. These components establish the baseline fuel and air metering for the carburetor; jetting may require verification when changing engine size, camshaft, intake system, altitude, or fuel requirements. Automatic choke configuration
Manufactured by FAJS. The carburetor uses parts identified as interchangeable with Italian- or Spanish-made DGV carburetors, subject to verification of the exact component, thread, and interface. Main jets, air correctors, idle jets, and the emulsion tube can be requested in alternate specifications at no additional cost.
Automatic electric-choke and water-choke configurations are also available separately. Confirm the required choke type before ordering if the vehicle installation depends on a specific electrical or coolant connection.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: ST2371.
What Is Included
- 32/36 DFEV carburetor with automatic choke
Important Fitment Note
Verify the carburetor family and the MPN ST2371 against the unit being replaced. Compare the removed carburetor with this unit for mounting-flange geometry, stud and bolt locations, throttle-linkage position, air-cleaner interface, fuel-inlet arrangement, vacuum connections, and choke type. Confirm that the vehicle uses the required automatic-choke configuration and that the intended replacement interface matches the existing manifold and fuel system.
Check the identification marking, jet and emulsion-tube requirements, and the thread, seat, and sealing style of any components being transferred or replaced. Compare the removed carburetor directly before installation; Weber, EMPI, and Holley replacement references do not by themselves confirm exact vehicle fitment.
What you see is what you get
Show all parts