PowerFlow electric FUEL PUMP 12V Cylindrical Universal Facet 476087 replacement$ 68.6 ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › Part number: 476087PowerFlow 12V Electric Fuel Pump – Cylindrical Facet 476087 Replacement Flow capacity is up to 30 US gallons per hour or 25 UK gallons per hour, with a maximum working pressure of 4.5–5.5 psi. These specifications make fuel-pressure verification important when replacing a mechanical pump or fitting an electric pump to a carbureted application. Excessive pressure can affect float-bowl fuel level control, while insufficient flow can contribute to fuel starvation during sustained load or high engine speed. 12V operation with 4.5–5.5 psi maximum working pressure The pump incorporates two spring-loaded valves, two O-rings for fuel sealing, and a top-end spring intended to protect the piston. The included fuel unions have an anti-slip surface to help maintain a secure hose connection. Correct mounting position is important: install the pump no higher than 24 inches (60 cm) above the bottom of the fuel tank. This placement helps the pump maintain a reliable fuel supply and reduces the risk of poor priming or fuel starvation. The unit is approved and tested and includes warranty coverage. Confirm that the vehicle’s electrical system, fuel-line arrangement, pressure requirement, hose interface, and available mounting position are suitable before installation. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: 476087. Technical role: 12V cylindrical electric fuel pump replacement for carbureted fuel systems, rated at 4.5–5.5 psi maximum working pressure. Service relevance: Verify fuel pressure and flow requirements when replacing a mechanical pump or installing this pump to help prevent fuel starvation or carburetor float-control issues. What Is Included PowerFlow 12V electric fuel pump, MPN 4760878 mm fuel unions with anti-slip surfacesInstallation manualWarranty coverage Important Fitment Note Verify the required pump family and code before ordering. Compare MPN 476087 and the Facet 476087 replacement reference with the number or marking on the removed pump. Check the fuel-line geometry, 8 mm union interface, hose connection method, electrical connection, mounting arrangement, and available position relative to the bottom of the fuel tank. Confirm that the application requires a low-pressure pump within the 4.5–5.5 psi range and that its carburetor or fuel system can accept the available flow rate. The pump must be mounted no higher than 24 inches (60 cm) above the bottom of the fuel tank. Compare the new pump and unions directly with the removed parts before installation; verify code, connection geometry, and fuel-pressure requirements rather than relying on appearance alone.What you see is what you getShow all parts
