RED Velocity Stacks Air horn trumpet WEBER 40 DCOE IDF DELLORTO DHLA 75mm
$ 79.2
Part number: ST3814
Made in: EU
RED Velocity Stacks Air Horn Trumpets for Weber 40 DCOE/IDF, Dellorto DHLA – 75mm, Pair
These red air horns mount at the carburetor inlet to provide a shaped entry into the throttle bore. They are used with Weber and Dellorto performance carburetors where the inlet geometry, available clearance, and air-entry characteristics are part of the intake-system setup. The velocity-stack profile can help maintain a smoother transition into the carburetor throat and may influence airflow behavior during progression, main-circuit operation, and transient throttle response.
75mm overall length with a 40mm internal diameter. The supplied air horns are listed for 40 DCOE, 40 DHLA, 40 ADDHE, and 40 IDF applications. Their bolt-on design allows installation at the carburetor mouth, but the mounting-hole pattern and inlet interface should be checked against the specific carburetor before ordering. They are finished in red anodized polished alloy and carry MPN ST3814x2.
A damaged or missing air horn can leave the carburetor inlet exposed and alter the intended entry profile. These components are an intake-entry accessory; they do not replace the carburetor’s jets, emulsion tubes, accelerator-pump components, or fuel-level control parts. Final carburetor calibration remains dependent on the complete engine, intake, exhaust, and air-filter arrangement.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: ST3814x2.
Technical role: Red anodized alloy velocity stacks provide a shaped inlet entry for Weber 40 DCOE/IDF and Dellorto 40 DHLA/ADDHE carburetors.
Service relevance: Replace damaged or missing air horns to restore the intended carburetor inlet profile without changing jets or other fuel-system components.
What Is Included
- Two red anodized alloy air horns/velocity stacks
- Made in EU.
Important Fitment Note
Verify the carburetor family and body marking before purchase: Weber 40 DCOE or 40 IDF, Dellorto 40 DHLA or 40 ADDHE. Confirm the 40mm inlet relationship, the mounting-face geometry, bolt-hole spacing, fastener arrangement, and available clearance for the 75mm overall length. Compare the flange, throat, and mounting interface with the removed air horn or the carburetor currently fitted.
Verify the actual carburetor code and mounting geometry rather than relying only on the nominal 40-size designation.
What you see is what you get
Show all parts