RED Velocity Stacks Air horns trumpets WEBER 40 DCOE IDF DELLORTO DHLA 15mm
$ 58.1
Part number: ST3809
Made in: EU
RED Velocity Stack Air Horns for Weber 40 DCOE / IDF, Dellorto DHLA and ADDHE Carburetors
These red velocity stacks, also called air horns or trumpets, mount to the air inlet of compatible 40-size Weber and Dellorto carburetors. The bellmouth entry guides incoming air into the carburetor mouth and can support smoother airflow into the main circuit, progression circuits, and enrichment passages. Air-horn length and inlet geometry can influence induction noise and transient response, so the replacement should match the original carburetor application and available clearance.
40 mm internal diameter and 15 mm total length. The air horns are made from aluminium alloy with a red anodized finish and use a bolt-on mounting arrangement. They are intended for verification against 40 DCOE, 40 DHLA, 40 ADDHE, and 40 IDF applications. The existing description also identifies Weber, Dellorto, and Solex carburetor use; confirm the exact carburetor body and mounting interface before installation. MPN: ST3809x2.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: ST3809x2.
Technical role: Red anodized aluminium velocity stacks provide a bellmouth air inlet for compatible Weber 40 DCOE/IDF and Dellorto DHLA carburetors.
Service relevance: Used to replace missing or damaged carburetor air horns while retaining the specified 15 mm stack length.
What Is Included
- Two red anodized aluminium-alloy velocity stack air horns
- Made in EU.
Important Fitment Note
Verify the carburetor family and code before ordering, including Weber 40 DCOE or IDF, Dellorto 40 DHLA or ADDHE, or the applicable Solex model. Check the 40 mm inlet geometry, 15 mm overall length, mounting-hole arrangement, fastener thread where applicable, and the seating interface against the carburetor face. Compare the new air horns directly with the removed parts, including flange shape, bolt spacing, inlet clearance, and air-filter or airbox clearance.
Do not rely on carburetor size alone; confirm the complete mounting geometry and code marking before installation.
What you see is what you get
Show all parts