Solex Pierburg 35 PDSI full service gasket kit repair for Opel$ 45 ‹ › ‹ › ‹ › ‹ › Part number: ST2666Made in: EUIncludes:Solex Pierburg 35 PDSI Full Service Gasket Kit Repair Kit ST2666 for Opel This full service gasket kit is intended for overhaul and resealing work on Solex/Pierburg 35 PDSI carburetors. It supports disassembly and reassembly by renewing gasket and seal interfaces that can contribute to air leaks, fuel seepage, unstable idle, or inconsistent carburetor operation when aged or damaged. For Solex/Pierburg 35 PDSI carburetors The kit is associated with applications including Opel Kadett, Ascona, Manta, and Rekord, Vauxhall Astra, and Ford applications using this carburetor family. It is a service and sealing kit rather than a replacement jet calibration set; the existing main circuit, progression, enrichment, and fuel-level settings should be checked during overhaul and returned to the correct specification for the carburetor. Use the supplied profiles and service components only after confirming that the carburetor body, cover, flange, and internal interfaces match. Correct gasket alignment is important because an incorrect profile can obstruct passages, create an air leak, or interfere with fuel control and transient response. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: st2666. Technical role: ST2666 is a full service gasket and seal kit for Solex/Pierburg 35 PDSI carburetor overhaul and resealing. Service relevance: It renews gasket, seal, and pictured small service-component interfaces that may contribute to air leaks, fuel seepage, or unstable operation when worn or damaged. What Is Included Solex/Pierburg 35 PDSI full service gasket kit, part number ST2666Gaskets, seals, and small carburetor service components pictured for the kitMade in EU. Important Fitment Note Verify the carburetor family and the 35 PDSI identification before ordering. Confirm the ST2666 part number where applicable, then compare the gasket outlines, bolt-hole pattern, passage openings, sealing surfaces, and any threaded or seated service components with the parts removed from the carburetor. Check that the needle-valve or other fuel-control interface, where replacement is required, matches the original geometry and seat arrangement. The listed vehicle applications include Opel Kadett, Ascona, Manta, and Rekord, Vauxhall Astra, and Ford applications, but exact fitment depends on the carburetor fitted to the vehicle. Compare every gasket profile and service interface with the removed part before installation.What you see is what you getShow all parts