THROTTLE LEVER LINKAGE KIT with Cable HOLDER Single WEBER 40/45 DCOE CARBURETOR$ 59.5 ‹ › ‹ › ‹ › ‹ › ‹ › Part number: ST3251Made in: EUIncludes:THROTTLE LEVER LINKAGE KIT WITH CABLE HOLDER FOR SINGLE WEBER 40/45 DCOE CARBURETOR This throttle lever linkage kit provides the mechanical connection between an accelerator cable and the throttle lever on a single Weber 40/45 DCOE carburetor. The cable holder supports the cable housing while the lever transfers cable movement to the carburetor throttle shaft, making it a service and conversion part for cable-operated throttle installations. MPN ST3251 Correct lever geometry and cable alignment are important for full throttle travel, reliable return movement, and proper throttle response. A worn, bent, or incorrectly positioned linkage can cause excess free play, restricted throttle opening, or inconsistent transient response. The kit has a yellow zinc finish. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST3251. Technical role: Connects the accelerator cable to the throttle lever and supports the cable housing on a single Weber 40/45 DCOE carburetor. Service relevance: Replacement addresses worn or bent linkage that may cause excess free play, restricted throttle opening, or inconsistent throttle response. What Is Included Throttle lever linkage kit with cable holder for a single Weber 40/45 DCOE carburetorMade in EU. Important Fitment Note Verify that the carburetor is a single Weber 40/45 DCOE unit and compare the MPN, lever profile, mounting-hole layout, cable-holder position, and throttle-shaft interface with the removed components. Check the mounting hardware arrangement, cable housing support, threaded interfaces, and available clearance before installation. Compare the new linkage directly with the removed part before fitting; DCOE lever geometry and cable interfaces can vary between applications.What you see is what you getShow all parts