Trumpet 40mm 3/2" Weber 45 DCOE slide in Velocity Stack BLACK air horn ram pipe
$ 35.8
Part number: AH4540b
Made in: EU
40 mm Weber 45 DCOE Slide-In Velocity Stack Air Horn – Black
This slide-in air horn, also called a velocity stack or ram pipe, fits the air-entry side of a Weber 45 DCOE carburetor. It provides a shaped inlet for the carburetor’s main air path and can influence airflow entry into the venturi system, with practical relevance to intake noise, air-entry behavior, and transient response. It does not replace or alter the carburetor’s jets, emulsion tubes, progression circuit, or fuel-level control components.
Designed for Weber 45 DCOE carburetors. The air horn has a 76 mm (3 inch) total length, with approximately 40 mm (1 1/2 inch) extending visibly from the carburetor inlet. Its slide-in interface makes correct inlet diameter, seating depth, and retaining method important during installation. Verify that the carburetor’s air-entry arrangement accepts this style of velocity stack before ordering.
The alloy air horn has a black finish and can be polished to a mirror finish using a cotton wheel if a polished appearance is preferred. Part number: AH4540b.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: AH4540b.
Technical role: Black alloy slide-in velocity stack for the air-entry side of a Weber 45 DCOE carburetor.
Service relevance: Supports air-entry assembly service or replacement where a 40 mm visible section and 76 mm total length are suitable.
What Is Included
- One black alloy slide-in air horn / velocity stack for Weber 45 DCOE
- Made in EU.
Important Fitment Note
Verify the Weber carburetor family and confirm the AH4540b marking before purchase. Compare the 40 mm visible section and 76 mm total length with the removed air horn or the available clearance in the intake system. Check the inlet geometry, slide-in diameter, seating depth, and any retaining or mounting interface; this part is identified as a slide-in air horn rather than a threaded component.
Always compare the new air horn directly with the removed part before installation, especially the inlet profile and retention method.
What you see is what you get
Show all parts