Universal adjustable Throttle Linkage Rod CUSTOM LENGTH ball joint Weber$ 53.4 ‹ › ‹ › ‹ › Part number: ST4250Made in: EUIncludes:Universal Adjustable Throttle Linkage Rod CUSTOM LENGTH Ball Joint Weber This universal adjustable throttle linkage rod connects a throttle actuator or linkage lever to a Weber carburetor throttle mechanism. The ball-joint ends accommodate changes in operating angle while the adjustable rod allows the center-to-center length to be set during installation. The rod length is supplied as a custom center-to-center measurement. Specify the required length when ordering. After installation, turning the rod provides approximately +8 mm or -8 mm of adjustment from the selected length, allowing the installer to remove excess slack and establish correct throttle lever movement. Adjustable center-to-center length with approximately 8 mm of adjustment in either direction. Proper linkage length helps support full throttle travel, reliable return movement, and clean transient response. A bent, worn, or incorrectly sized linkage can contribute to delayed throttle response, incomplete throttle opening, or excess free play. The rod is made from stainless steel and carries MPN adjlink. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: adjlink. What Is Included Adjustable stainless-steel throttle linkage rod with ball-joint endsMade in EU. Important Fitment Note Verify the Weber carburetor family, any marking or code associated with the existing linkage, and the required center-to-center length before ordering. Check the ball-joint geometry, attachment interface, thread arrangement, and available operating angle against the removed rod and the throttle levers on the carburetor. Confirm that the selected length allows full closed-throttle return and full throttle opening without binding. Compare the replacement with the removed linkage before installation; universal adjustment does not confirm compatibility with every Weber configuration. Lengths above 30 cm may require confirmation of an additional charge.What you see is what you getShow all parts
