Weber 38 DCN Carburetor Air Horn Set Ferrari 250$ 144.8 ‹ › ‹ › ‹ › ‹ › ‹ › Weber 38 DCN Carburetor Air Horn Set Ferrari 250 This air horn set is intended for one Weber 38 DCN carburetor and carries MPN 52840.010. The two air horns form the carburetor inlet entry, helping present a smoother transition into the main air passages and providing the correct upper-inlet geometry for the carburetor assembly. They are suitable for restoration or replacement when original horns are missing, damaged, or corroded. The set also includes a jet cover and the associated mounting hardware. The jet cover helps protect and close the upper jet area, while the studs, nuts, tab, and fixing screw secure the air horn and cover components during assembly. For one Weber 38 DCN carburetor Each air horn has a 55 mm top diameter and an approximate visible length of 60 mm. Air horns influence inlet airflow and transient response, but they do not replace correct jetting, emulsion calibration, fuel-level control, or general carburetor adjustment. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: 52840.010. What Is Included 2 air horns1 jet cover1 air horn tab1 air horn tab fixing screw2 jet cover studs2 nuts3 spring washers Important Fitment Note Verify that the carburetor is a Weber 38 DCN and compare the MPN 52840.010, air horn spacing, 55 mm inlet diameter, visible horn length, and upper mounting arrangement with the removed parts. Check the tab position, fixing-screw location, jet-cover shape, stud spacing, nut engagement, and the applicable seat or interface surfaces before installation. Compare the complete geometry and mounting hardware with the original assembly before ordering. Exact Ferrari 250 fitment should be confirmed against the carburetor identification and the original air horn and jet-cover arrangement.What you see is what you getShow all parts
