WEBER 44 IDF CARBURETOR BASE GASKETS - PAIR, Dellorto DRLA$ 4.6 ‹ › ‹ › Part number: ST4088Made in: EUIncludes:WEBER 44 IDF Carburetor Base Gaskets - Pair, Dellorto DRLA These base gaskets seal the mounting interface between a Weber 44 IDF carburetor and its mating manifold or adapter surface. Proper sealing is important for maintaining controlled airflow through the carburetor; a damaged, compressed, or incorrectly matched gasket can allow an intake air leak that affects idle quality, progression, mixture adjustment, and transient response. The pair is also intended for Dellorto DRLA applications. MPN: 2xST4060 These gaskets are sealing components, not carburetor calibration parts, and do not alter jetting, emulsion, enrichment, or fuel-level control. Replace the gasket when servicing or removing the carburetor, particularly if the existing seal shows compression damage, tearing, distortion, or evidence of air leakage. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: 2xST4060. Technical role: Pair of base gaskets for sealing the mounting interface on Weber 44 IDF and Dellorto DRLA carburetors. Service relevance: Replace during carburetor removal or when the existing gasket shows compression damage, tearing, distortion, or signs of an intake air leak. What Is Included Two carburetor base gasketsMade in EU. Important Fitment Note Verify the carburetor family and the 44 IDF or Dellorto DRLA application before installation. Compare the gasket’s bolt-hole pattern, internal opening, overall outline, and mounting geometry with the carburetor base and mating manifold or adapter. Check the MPN marking 2xST4060 where applicable, and compare the new gasket directly with the removed part. Thread and seat-style checks apply to the associated mounting interface; confirm that the studs, fasteners, and sealing faces align without forcing the gasket into position. Always verify the complete interface and removed gasket before fitting, especially where adapters or modified manifolds are used.What you see is what you getShow all parts
