Weber 45 DCOE full maxi Service Gasket kit repair rebuild set$ 74.7 ‹ › ‹ › ‹ › Part number: ST2209Made in: EUIncludes:Weber 45 DCOE Full Maxi Service Gasket Kit Repair Rebuild Set Service and repair kit for Weber 45 DCOE carburetors, MPN ST2209. The kit supports refurbishment of the carburetor’s sealing points and selected fuel-control and adjustment components. Replacing aged cover gaskets helps control air and fuel leakage around the top cover, bottom cover, inspection cover, and jet cover during rebuild work. The included fuel filter, float pivot pin, and float needle valve components support service of the float chamber and fuel-level control system. Correct float movement and needle-valve sealing are important for stable fuel level, while the idle mixture screws support adjustment of the idle and progression circuits. The supplied screws, nuts, locking nuts, and sealed ball bearings provide additional service parts for matching 45 DCOE assemblies. Service kit for Weber 45 DCOE carburetor rebuilding and gasket replacement. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST2209. Technical role: Full maxi service kit for rebuilding Weber 45 DCOE carburetors, including gaskets, float-control parts, idle mixture screws, and related hardware. Service relevance: Supports replacement of cover and jet-cover seals plus servicing of the fuel filter, float pivot, needle valve, and idle adjustment components. What Is Included Gasket and sealing components for the Weber 45 DCOE service pointsFuel filterFloat pivot pinFloat needle valveScrews for the top cover and related cover serviceBottom cover, inspection cover, and jet cover gasketsIdle mixture screwsNuts and locking nutsSealed ball bearingsMade in EU. Important Fitment Note Verify the carburetor family and the 45 DCOE identification before ordering, including any code or marking stamped on the carburetor body. DCOE variants and production revisions may use different gasket outlines, screw locations, thread sizes, seat arrangements, or component interfaces. Compare the kit’s gasket geometry, openings, fastener threads, needle-valve seat arrangement, float-pivot design, and bearing interface with the removed parts before installation. Confirm the carburetor code and compare every replacement part with the removed component before disassembly or assembly.What you see is what you getShow all parts
