Steel Worm Gear Hose Clamp Clip size 8-12mm 1/3-1/2" Pipe Tube
$ 1.1
Part number: ST2338
Made in: EU
Steel Worm Gear Hose Clamp Clip 8-12mm / 1/3-1/2" Pipe Tube - MPN HS08
This steel worm gear hose clamp secures a compatible hose or tube over a barb, pipe, or fitting. Tightening the worm-drive screw reduces the band diameter around the hose, helping maintain a firm seal and preventing the hose from pulling off during service. It can be used in automotive and general mechanical hose applications where the clamp range, band geometry, and hose material are suitable.
Clamping range: 8-12mm / 1/3-1/2"
The clamp is relevant to carburetor and fuel-system service when the hose outside diameter falls within the stated range and the clamp is appropriate for the application. It may also be used on vacuum, air, coolant, or other low-pressure hose connections after confirming compatibility. Correct sizing is important: a clamp that is too large may not seal evenly, while excessive tightening can damage or cut into the hose. MPN HS08 identifies this clamp specification.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: hs08.
What Is Included
- Steel worm gear hose clamp clip, size 8-12mm / 1/3-1/2", MPN HS08
- Made in EU.
Important Fitment Note
Verify the clamp family and size against the hose outside diameter, not only the nominal pipe or fitting size. Confirm the HS08 marking or part reference where applicable, then compare the band width, worm-screw housing, adjustment geometry, and hose-to-fitting interface with the removed clamp. Check that the hose seats fully over the barb or pipe and that the clamp can sit behind the fitting bead or barb without contacting a sharp edge.
Verify the hose diameter, clamp range, band geometry, and fitting interface before installation.
Compare the replacement with the original for screw orientation and available tightening access. Confirm that the application does not require a different clamp design, thread arrangement, sealing method, or higher-rated connection.Show all parts