Air corrector jet Dellorto DHLA 130-140-150-160-170-180-190-200-210-220-230-240
$ 6.4
Part number: 7485
Made in: EU
Air Corrector Jet for Dellorto DHLA / DRLA Carburetors – MPN 7485
This air corrector jet is used in the main metering circuit of Dellorto DHLA and DRLA carburetors. It controls the air bleed entering the emulsion system, helping shape the fuel curve as engine speed and airflow increase. Correct air-corrector selection is important for upper-rpm mixture control, main-circuit progression, and consistent response after the carburetor transitions away from the idle and progression circuits.
MPN 7485 air corrector jet for Dellorto DHLA / DRLA applications. Available calibration sizes range from 120 through 250 in increments of 5, including 130, 135, 140, 145, 150, 155, 160, 165, 170, 175, 180, 185, 190, 195, 200, 205, 210, 215, 220, 225, 230, 235, 240, 245, and 250. An air corrector that is not matched to the carburetor calibration can contribute to an excessively rich or lean mixture at higher engine speed, poor main-circuit transition, or a flat response under sustained load. Select the required size according to the existing calibration and engine setup.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: 7485.
What Is Included
- One Dellorto DHLA / DRLA air corrector jet, MPN 7485
- Selected calibration size from the available range
- Made in EU.
Important Fitment Note
Verify the carburetor family before ordering: this jet is intended for Dellorto DHLA and DRLA applications. Confirm the MPN or marking, the selected size, and the jet’s threaded geometry, seat style, and installation interface against the removed part. Compare the new jet directly with the original air corrector, including thread form, seating arrangement, overall profile, and marking.
Verify the required calibration size and physical interface before purchase; DHLA and DRLA components should not be matched by appearance alone.
Please provide the selected size with the order message so the correct calibration can be supplied.
What you see is what you get
Show all parts