Inlet manifold MGA/MGB Weber 40/45 DCOE Dellorto DHLA short 90mm intake
$ 161.7
Part number: ST3890
Manufacturer: FAJS
Inlet Manifold MGA/MGB Weber 40/45 DCOE Dellorto DHLA Short 90mm Intake
This short-type 90 mm inlet manifold is used to mount a Weber DCOE or Dellorto DHLA carburetor to the intake side of a four-cylinder MGA or MGB engine. It provides the mechanical connection between the carburetor and cylinder-head intake ports, with manifold geometry and fastener position determining whether the assembly can be installed correctly.
The primary application is Weber 45 DCOE and Dellorto 45 DHLA carburetors. The listed carburetor range also includes Weber 38, 40, 45 and 48 DCOE units, plus Dellorto 40 and 45 DHLA units. Listed vehicle applications include 1954–1962 MGA 1500/1600 models and 1963–1974 MGB 1800 models. It does not apply to the MGA Twin Cam.
Short 90 mm manifold for DCOE and DHLA carburetor conversions. A correctly matched manifold supports proper port alignment, secure carburetor mounting and effective intake sealing. Incorrect shape, bolt spacing or port position can prevent installation, create an intake air leak, or disturb mixture control through the progression and main circuits. Verify the manifold against the engine and carburetor before fitting, particularly when replacing a different manifold design.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: st3890.
What Is Included
- ST3890 short 90 mm inlet manifold
Important Fitment Note
Verify the carburetor family and code before purchase: Weber DCOE and Dellorto DHLA interfaces are not interchangeable unless the manifold mounting pattern matches. Check the manifold shape, carburetor flange geometry, port layout, bolt or screw position, and the applicable thread and sealing-seat arrangement. Compare these points directly with the removed manifold and confirm the engine application, including MGA 1500/1600, MGB 1800, and exclusion of MGA Twin Cam.
Compare the mounting pattern and port alignment with the removed part before installation.
What you see is what you get
Show all parts