Weber carburetor 32/36 DFEV service gasket full kit repair set
$ 60.2
Part number: ST3515
Manufacturer: FAJS
Weber Carburetor 32/36 DFEV Service Gasket Full Kit Repair Set
This service gasket kit is intended for rebuilding and resealing Weber 32/36 DFEV carburetors during cleaning, inspection, or corrective repair. The gaskets and seals help restore proper separation between fuel passages, air passages, covers, throttle-body interfaces, and mounting surfaces where leakage or air entry can affect carburetor operation.
A worn gasket can contribute to fuel seepage, vacuum leaks, unstable idle, difficult adjustment, or inconsistent progression from the idle circuit into the main circuit. Replacing the sealing components during disassembly also helps protect fuel-level control and predictable transient response after the carburetor is returned to service. MPN: ST3515
This is a gasket and sealing service kit for the Weber 32/36 DFEV carburetor family. It is not a jet or calibration kit, so final mixture and main-circuit tuning remain dependent on the carburetor’s existing calibration and engine requirements.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: st3515.
Technical role: Full gasket and seal service set for rebuilding and resealing Weber 32/36 DFEV carburetors; it is not a jet or calibration kit.
Service relevance: Replacement sealing components support repair of fuel seepage, vacuum leaks, and disturbed gasket interfaces during carburetor disassembly.
What Is Included
- Weber 32/36 DFEV service gasket and seal set
- Gaskets, seals, and small service components shown for carburetor repair
Important Fitment Note
Verify that the carburetor is a Weber 32/36 DFEV and compare the carburetor code, body layout, gasket openings, bolt-hole pattern, and sealing interfaces with the removed parts before installation. Check the geometry and position of each gasket, along with any applicable seat or threaded interface, rather than relying only on the 32/36 designation. Compare every replacement gasket with the removed part before applying sealant or tightening the carburetor.
What you see is what you get
Show all parts