Weber 45 DCOE Service Gasket kit repair rebuild set+fuel filter+valve+pin+screws$ 37.4 ‹ › ‹ › ‹ › ‹ › Part number: ST3239Made in: EUIncludes:Weber 45 DCOE Service Gasket Kit Repair Rebuild Set ST3239 This service kit supports gasket replacement and fuel-level control maintenance on Weber 45 DCOE carburetors. The gasket components seal the carburetor covers and inspection interfaces, helping prevent air or fuel leakage during overhaul work. The included fuel filter protects the inlet side, while the float pivot pin supports float movement and the float needle valve regulates fuel entry into the float chamber. Correct float operation and needle-valve control are important because fuel level directly influences metering through the main circuit, progression and enrichment circuits. Wear, contamination or leakage in these areas can contribute to unstable fuel level, poor transient response, flooding or difficult tuning. For Weber 45 DCOE service and rebuild work. The included screws are intended for the top cover, bottom cover and inspection cover. During installation, clean the mating surfaces, inspect the cover faces for distortion and confirm that the replacement gaskets align correctly before tightening the covers. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST3239. Technical role: Service and rebuild kit for Weber 45 DCOE carburetors, including gaskets, fuel filter, float pivot pin, needle valve and cover screws. Service relevance: Supports sealing, inlet filtration, float movement and fuel-level control during Weber 45 DCOE overhaul work. What Is Included Gasket set for Weber 45 DCOE carburetorsFuel filterFloat pivot pinFloat needle valveScrews for the top cover, bottom cover and inspection coverMade in EU. Important Fitment Note Verify the carburetor family as Weber 45 DCOE and compare the MPN ST3239 with the required service kit before ordering. Check the gasket outlines, openings and bolt-hole geometry against the removed parts. Also verify the float pivot-pin arrangement, needle-valve interface and seat style, filter connection and the screw thread, length and head style against the original components. Compare every gasket and fitting with the removed part before installation; DCOE variants can differ in cover geometry and service interfaces.What you see is what you getShow all parts