UNIVERSAL CARBURETOR THROTTLE LEVER ARM SET Solex ADDHE,PHH,PII,Weber DG,Holley$ 12.2 ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › Part number: ST2231Made in: EUIncludes:Universal Carburetor Throttle Lever Arm Set ST2231 for Solex, Weber and Holley This throttle lever arm transfers carburetor shaft movement to the external throttle linkage, cable, or ball-joint connection. It is used when servicing or adapting carburetors that require a replacement lever on an 8 mm shaft interface. Correct lever position and linkage alignment are important for consistent throttle opening, reliable return-to-idle action, and predictable transient response. The set is listed for Solex ADDHE, PHH, and PII carburetors, Weber 32/36 DG, DGV, DGAV, and DGAS carburetors, Holley 5200 carburetors, and other carburetors using a compatible 8 mm shaft arrangement. The lever includes multiple linkage-position holes for selecting a suitable connection point during installation. 8 mm ball joint ready The ball joint itself is not included. A bent, loose, corroded, or incorrectly positioned throttle arm can restrict full throttle travel, alter the opening ratio, or prevent the throttle plates from returning correctly. Verify the arm orientation and linkage path before final tightening so the carburetor reaches its intended closed and open positions without binding. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST2231. What Is Included Universal throttle lever armRetaining nutLock washerMade in EU. Important Fitment Note Verify the carburetor family and model marking before ordering, including Solex ADDHE, PHH, or PII; Weber DG-series variants; and Holley 5200 applications. Confirm the shaft diameter and interface, lever geometry, center opening, linkage-hole position, and the available nut-and-washer seating arrangement. This set is intended for compatible 8 mm shaft carburetors, but shaft shape and lever orientation can vary between applications. Compare the new lever directly with the removed part before installation. Check that the shaft interface seats fully, the lever aligns with the original throttle direction, and the linkage or 8 mm ball joint can move through its full range without interference. The 8 mm ball joint is not included. https://www.ebay.com/itm/Weber_universal_lever https://www.ebay.com/itm/Dellorto_universal_lever https://www.ebay.com/itm/Solex_universal_lever https://www.ebay.com/itm/Weber_universal_lever/291506950117 https://www.ebay.com/itm/Dellorto_universal_lever/291625579216 https://www.ebay.com/itm/Solex_universal_lever/301809221219What you see is what you getShow all parts