Stepped rubber mounting sleeve Weber 40 IDF EMPI HMPX/DRLA intake VW T1 set
$ 38.1
Part number: ST3506
Manufacturer: FAJS
Stepped Rubber Mounting Sleeve Weber 40 IDF EMPI HMPX/DRLA Intake VW T1 Set
This stepped rubber mounting sleeve set provides the flexible connection between the carburetor and intake manifold on compatible Weber 40 IDF, EMPI HMPX, and DRLA intake applications associated with VW Type 1 installations. The sleeve transitions between the supported 42 mm and 38 mm connection sizes, allowing the mating components to be joined through a clamped rubber interface.
42 mm-to-38 mm stepped connection The rubber sleeve helps maintain the intake seal while accommodating the change in connection diameter and supporting the carburetor-to-manifold joint. A split, hardened, or poorly seated sleeve can allow unmetered air into the intake, contributing to unstable idle mixture, inconsistent progression, hesitation during transient throttle response, or difficult carburetor tuning. Replace the mounting sleeve when its sealing surface or clamping area is no longer serviceable.
Part number: ST3506.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: st3506.
Technical role: Stepped rubber sleeves provide a clamped 42 mm-to-38 mm connection between compatible carburetors and intake manifolds.
Service relevance: Replace split, hardened, or poorly sealing sleeves that may admit unmetered air and affect idle or carburetor tuning.
What Is Included
- Set of stepped rubber mounting sleeves with a 42 mm-to-38 mm transition
Important Fitment Note
Verify the carburetor and intake family before ordering, including Weber 40 IDF, EMPI HMPX, or DRLA application requirements. Confirm the ST3506 part number, the 42 mm-to-38 mm stepped geometry, the bore and outside-diameter relationship, and the clamp seating surfaces on both mating components.
This is a clamped rubber mounting interface rather than a threaded or conventional flanged connection. Check the available seat area, sleeve profile, and clamp position against the removed part and the intake assembly. Compare the new sleeve directly with the removed part before installation, including diameter transition, orientation, and sealing surfaces.
What you see is what you get
Show all parts