STAINLESS COLD START CHOKE COVER WEBER 36/40/42/45 DCOE 40/44/48 IDF DCNF EMPI$ 13.7 ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › Part number: ST3227Made in: EUIncludes:STAINLESS COLD START CHOKE COVER WEBER 36/40/42/45 DCOE 40/44/48 IDF DCNF EMPI This stainless cold-start choke cover is used at the cold-start enrichment assembly on compatible Weber and EMPI carburetors. It provides a replacement or service cover for the choke/enrichment mechanism, helping restore the correct external cover, mounting interface, and finished appearance during carburetor refurbishment. Stainless steel construction with a mirror finish. The cover is intended for Weber 36/40/42/45 DCOE, 40/44/48 IDF, and DCNF applications, as well as compatible EMPI carburetors. It is a hardware and enclosure component, not a main jet, emulsion tube, fuel-level control part, or progression calibration component, so it does not directly set mixture flow or transient response. The supplied part carries MPN 52135.008. Confirm the carburetor family and cold-start assembly before installation, particularly when replacing a missing, damaged, corroded, or cosmetically worn cover during restoration or service. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: 52135.008. Technical role: Stainless replacement cover for the cold-start choke/enrichment assembly on compatible Weber and EMPI carburetors. Service relevance: Suitable for replacing a missing, damaged, corroded, or cosmetically worn cover during carburetor service or refurbishment. What Is Included Stainless steel cold-start choke cover with mirror finishMPN 52135.008Made in EU. Important Fitment Note Verify the carburetor family and compare the cover with the removed part before installation. Check the Weber or EMPI identification, the 36/40/42/45 DCOE, 40/44/48 IDF, or DCNF application, the cover outline, mounting-hole pattern, fastener locations, and the related gasket or seat interface. Where applicable, confirm the fastener thread and mounting interface match the original cold-start assembly. Do not rely on carburetor model family alone; compare the actual cover geometry and mounting interface with the part being replaced.What you see is what you getShow all parts