RED Velocity Stacks Air horns trumpets WEBER 40 DCOE IDF DELLORTO DHLA 50mm
$ 58.3
Part number: ST3812
Made in: EU
RED Velocity Stacks Air Horns Trumpets for Weber 40 DCOE IDF and Dellorto DHLA 50mm
These red velocity stacks, also called air horns or intake trumpets, fit at the carburetor inlet and provide a smoother entry path for incoming air. They are intended for Weber 40 DCOE and IDF carburetors and Dellorto DHLA applications, with a 50 mm specification identified by the product listing.
Pair of red velocity stacks The flared bellmouth helps guide air into the carburetor throat, supporting consistent airflow into the main circuit and improving the inlet conditions that influence fuel signal and transient response. The stacks do not replace jets or directly adjust fuel level control, but their length, inlet profile, and installation position can affect airflow behavior and final carburetor calibration.
The mounting interface must be checked against the carburetor body before installation. Confirm that the stack throat, flange shape, mounting-hole layout, and available clearance match the intended Weber or Dellorto application. Allow sufficient space for linkage movement, surrounding components, and any air filtration system.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: ST3812x2.
What Is Included
- Two red velocity stacks / air horns, MPN ST3812x2
- Made in EU.
Important Fitment Note
Verify the carburetor family and any identification or code marking before purchase. Check the 50 mm specification against the removed trumpet or carburetor inlet, then compare the throat geometry, flange profile, mounting-hole spacing, and fastening interface. Also confirm stack length and surrounding clearance for the specific installation, especially where air filters, bonnet clearance, throttle linkage, or adjacent carburetors are involved.
Compare the new stacks directly with the removed parts before installation; visual similarity alone does not confirm the correct interface.Show all parts