WEBER 40 IDA 3C main venturi choke tube 30mm 32mm 34mm 36mm 38mm$ 24.5 ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › Part number: 71502Made in: EUCompatible with:Family: WEBER40 IDA 3C (3 pcs)Family: IDA40 IDA 3C - pn: 34894.002 (3 pcs)40 IDA 3C-3C-1 - pn: 34894.002 (3 pcs)Family: IDL40 IDL 3C1-2-3 - pn: 34894.002 (3 pcs)Family: IF40 IF 3C1-2-3-4 - pn: 34894.002 (3 pcs)WEBER 40 IDA 3C Main Venturi Choke Tube – 30 mm, 32 mm, 34 mm, 36 mm or 38 mm This main venturi, also called a choke tube, is used in the main air and fuel circuit of a Weber 40 IDA 3C carburetor. Its internal restriction accelerates airflow through the venturi area, helping create the pressure signal that draws fuel from the main circuit and supports fuel atomization as engine airflow increases. Available sizes: 30 mm, 32 mm, 34 mm, 36 mm and 38 mm. The selected diameter influences the balance between airflow capacity and main-circuit signal strength. A smaller venturi can increase signal intensity and support response at lower engine speeds, while a larger venturi can provide greater airflow capacity when the engine and other carburetor calibrations require it. Final selection should match the engine specification, operating range, and existing Weber calibration. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: 71502. Technical role: Main venturi choke tube for the Weber 40 IDA 3C carburetor, shaping airflow and the main-circuit fuel signal. Service relevance: Available in 30 mm, 32 mm, 34 mm, 36 mm and 38 mm sizes to support different airflow and calibration requirements. What Is Included One Weber 40 IDA 3C main venturi choke tube in the selected size: 30 mm, 32 mm, 34 mm, 36 mm or 38 mmMPN 71502Made in EU. Important Fitment Note Confirm that the carburetor is a Weber 40 IDA 3C before selecting this part. Verify the size marking, internal diameter, external seating geometry, mounting interface and relationship to the existing main-stack components. Compare the replacement directly with the removed venturi, including its marking and seating surfaces, before installation. Verify the required diameter and interface against the removed part; size alone does not confirm fitment. Different venturi sizes alter the carburetor’s airflow and main-circuit signal, so the selected tube should be considered alongside the engine’s air demand, main jets, emulsion tubes and overall calibration.What you see is what you getShow all parts