Universal adjustable Throttle Linkage Rod 4" swivel ball joint Weber Carburetor$ 22 ‹ › ‹ › Part number: ST2559Made in: EUIncludes:Compatible with:Family: WEBER40 DCOE early type (1 pc)40 DCOE late type (1 pc)40 DCOM 6/7 (1 pc)45 DCOE early (1 pc)Universal Adjustable Throttle Linkage Rod 4" Swivel Ball Joint for Weber Carburetor This adjustable throttle linkage rod is used in Weber carburetor linkage applications to connect the carburetor throttle lever with the external throttle mechanism. Its swivel ball-joint ends accommodate the angular movement required as the throttle shaft opens and closes, helping maintain a workable linkage path where the mounting points are not perfectly aligned. The rod length adjusts by turning the rod, allowing setup changes without replacing the linkage. Adjustment range is 4" to 4 1/2" (100 to 115 mm). Correct linkage length is important for throttle-lever position, idle-stop clearance, progressive opening, and reaching the intended full-throttle position without binding or over-travel. A rod that is too short, too long, or incorrectly aligned may contribute to incomplete throttle opening, unstable return to idle, or poor transient response. Part number ST2559. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST2559. Technical role: Adjustable throttle linkage rod with swivel ball-joint ends for connecting a Weber carburetor throttle lever to an external throttle mechanism. Service relevance: Adjustable length and swiveling ends help accommodate linkage angle changes while supporting correct throttle opening and return-to-idle alignment. What Is Included Universal adjustable throttle linkage rod with swivel ball-joint endsMade in EU. Important Fitment Note Verify the carburetor family and Weber application before ordering. Confirm the required adjustment range, ball-joint geometry, linkage angle, thread and retaining interface, and available clearance around the throttle lever. Compare the swivel ends and overall length with the removed rod, especially if the original linkage uses a specific ball size, stud arrangement, or retainer style. Verify the original rod length and end interfaces before installation; “universal” does not confirm compatibility with every Weber linkage configuration.What you see is what you getShow all parts