THROTTLE LEVERS LINKAGE for DUAL WEBER DCOE CARBURETOR 38mm extra long arm$ 38.1 ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › Part number: RPL-BELMade in: EUIncludes:THROTTLE LEVERS LINKAGE for DUAL WEBER DCOE CARBURETOR 38mm EXTRA LONG ARM This throttle lever linkage is designed for dual Weber DCOE carburetors and transfers external linkage movement to the carburetor throttle mechanism. The push-down type lever arrangement is used where the actuation direction and linkage geometry require downward movement to operate the throttle shaft. The 38 mm extra-long arm provides a defined lever length for linkage positioning and throttle-opening leverage. Correct lever geometry is important when synchronizing dual carburetors, setting initial throttle opening, and maintaining consistent progression from the idle circuit into the main circuit. A damaged, bent, or incorrect lever can cause unequal throttle opening, poor synchronization, delayed response, or interference with adjacent linkage components. The assembly uses a left-hand and right-hand lever configuration for dual-carburetor linkage applications. The yellow-zinc finish provides the identified surface finish for the part. Verify the lever orientation and mounting interface before installation, particularly when replacing an original linkage with a different arm length or actuation direction. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: RPL-BEL. Technical role: 38 mm extra-long push-down throttle lever linkage for transferring external actuation to dual Weber DCOE carburetor throttle mechanisms. Service relevance: Supports matched throttle movement and synchronization on dual-carburetor setups when the existing lever is damaged, bent, or incorrectly sized. What Is Included One left-hand throttle lever and one right-hand throttle lever for dual Weber DCOE carburetors38 mm extra-long, push-down type lever configurationMPN RPL-BELMade in EU. Important Fitment Note Confirm that the carburetor family is Weber DCOE and compare the MPN, lever orientation, and 38 mm arm measurement with the removed part. Check the throttle-shaft interface, mounting-hole geometry, linkage position, and push-down operating direction before fitting. Also verify clearance through the full throttle range and ensure the left/right lever arrangement matches the linkage layout on both carburetors. Compare the replacement directly with the removed lever before installation; arm length, orientation, and shaft interface must match the existing linkage system.What you see is what you getShow all parts