Weber 38/40/42/45/48/50 DCOE Complete set of all screws & washers$ 12.2 ‹ › ‹ › ‹ › ‹ › Part number: ST2359Made in: EUIncludes:Weber 38/40/42/45/48/50 DCOE Complete Screw and Washer Set ST2359 Complete replacement hardware set for servicing compatible Weber DCOE carburetors. The kit provides the screws and washers used during carburetor disassembly and reassembly, helping restore correct clamping and component retention after maintenance or refurbishment. Complete screw and washer set for DCOE service. Correct fastener thread, length, head style, and washer arrangement are important when rebuilding a carburetor, since incorrect hardware can damage threaded holes, interfere with moving components, or prevent proper seating of covers and assemblies. This is a mechanical service kit rather than a fuel-metering component, so it does not alter jetting, emulsion, fuel level control, progression, enrichment, or transient response calibration. The application information covers Weber 40, 45, and 48 DCOE carburetors, while the product identification also references 38, 42, and 50 DCOE models. Verify the exact carburetor version and hardware arrangement before installation. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST2359. Technical role: Complete replacement screw-and-washer hardware set for compatible Weber 38/40/42/45/48/50 DCOE carburetors, supporting mechanical assembly rather than fuel metering. Service relevance: Supports carburetor disassembly and reassembly by restoring fastener clamping and component retention during service or refurbishment. What Is Included Complete set of screws and washers for compatible Weber DCOE carburetor serviceMPN ST2359Made in EU. Important Fitment Note Verify the Weber DCOE family, carburetor model number, and identification code before ordering. Compare the screw count, thread form, overall length, head style, washer arrangement, and seating interface with the removed hardware. Check that each replacement fastener matches the original location and does not project into throttle-shaft, linkage, float, or internal passage areas. Compare the complete kit with the removed screws and washers before installation, especially when servicing a less common DCOE variant.What you see is what you getShow all parts