Velocity Stack Air horn ram pipe trumpet WEBER 40 DCOE IDF DELLORTO DHLA 75mm
$ 32.3
Part number: ST2609
Made in: EU
Velocity Stack Air Horn Ram Pipe Trumpet for Weber 40 DCOE/IDF and Dellorto DHLA - 75 mm
This velocity stack air horn mounts at the carburetor inlet to provide a bellmouth entry into the throat. The flared profile helps guide incoming air into the carburetor and can reduce abrupt inlet-edge turbulence, supporting consistent airflow into the main and progression circuits. It is an inlet component rather than a jet or fuel-metering part, so its service role is air-entry management, clearance control, and inlet-tract configuration.
The air horn uses a bolt-on mounting arrangement and is identified for Weber 40 DCOE, Weber 40 IDF, Dellorto 40 DHLA, and Dellorto 40 ADDHE carburetors. Solex applications require interface verification before purchase. 75 mm overall length and 40 mm internal diameter should be checked against the available airbox, filter, bonnet, and adjacent component clearance. The 75 mm inlet extension can also influence the effective inlet tract and should be considered when servicing or recalibrating a carburetor installation.
The component is made from polished alloy and carries MPN AH4075BO. Confirm the carburetor family and mounting interface before fitting, particularly where the carburetor has been modified or uses an adapter plate.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: AH4075BO.
Technical role: A polished-alloy 75 mm velocity stack providing a bellmouth air entry for Weber 40 DCOE/IDF and Dellorto DHLA carburetors.
Service relevance: It manages carburetor inlet airflow and tract configuration rather than fuel metering, so surrounding airbox and bonnet clearance are relevant.
What Is Included
- One polished alloy velocity stack air horn / ram pipe
- Made in EU.
Important Fitment Note
Verify the carburetor family and exact body marking: Weber 40 DCOE, Weber 40 IDF, Dellorto 40 DHLA, Dellorto 40 ADDHE, or the applicable Solex model. Compare the flange geometry, mounting-hole pattern, inlet opening, seating surface, and any thread or fastener interface with the removed air horn or carburetor face. Also confirm that the 40 mm internal diameter and 75 mm overall length suit the carburetor entry and surrounding clearance.
Compare the mounting interface and dimensions with the removed part before installation; model-family names alone do not confirm interchangeability.
What you see is what you get
Show all parts