Weber 34DMTR Service kit repair rebuild tune up gasket set +175 valve+filter+pin$ 38.1 ‹ › ‹ › ‹ › ‹ › ‹ › ‹ › Part number: ST2565Made in: EUIncludes:Weber 34 DMTR Carburetor Service Kit ST2565 – Gasket Set with 175 Valve, Filter and Float Pin This service kit is intended for maintenance and rebuild work on Weber 34 DMTR carburetors. The gasket set restores sealing at serviced carburetor joints, helping prevent unwanted air leaks and fuel leakage when the carburetor is reassembled with clean, undamaged mating surfaces. The kit includes a float needle valve with a 175 size specification. This valve controls fuel entry into the float bowl and works with the float to maintain fuel level. A worn, contaminated, or incorrectly sized valve can contribute to flooding, fuel starvation, unstable mixture control, or inconsistent transient response. Includes a 175-size float needle valve. The float pivot pin supports the float hinge during fuel-level control, while the fuel filter helps protect the inlet circuit from debris. During service, inspect the float, needle-valve seat, pivot area, gasket surfaces, and mounting hardware before assembly. Confirm that the replacement gaskets match the carburetor openings and bolt pattern before removing the original parts. This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing. Reference/MPN: ST2565. Technical role: ST2565 is a Weber 34 DMTR service and rebuild kit containing gaskets, a 175-size float valve, fuel filter, and float pivot pin. Service relevance: The included parts support resealing the carburetor and servicing fuel-level control, inlet filtration, and float-hinge components. What Is Included Weber 34 DMTR carburetor gasket set175-size valveFuel filterFloat pivot pinFloat needle valveMade in EU. Important Fitment Note Verify the carburetor family as Weber 34 DMTR and compare the ST2565 kit contents with the parts removed from the carburetor. Check the gasket geometry, mounting holes, passages, and openings before installation. For the float needle valve, verify the 175 size together with the thread, seat style, inlet interface, and installed height against the original valve and carburetor body. Compare the replacement parts directly with the removed components before assembly. If a different valve size is required, confirm the correct size and availability before ordering.What you see is what you getShow all parts
