Dellorto 40/45/48 DHLA Carburetor Throttle linkage side Single Cable Top Mount
$ 135.7
Part number: ST4377
Manufacturer: FAJS
Dellorto 40/45/48 DHLA Carburetor Throttle Linkage Side Single Cable Top Mount
Top-mount single-cable throttle linkage for Dellorto 40, 45, and 48 DHLA carburetors. The linkage is used on dual-carburetor installations to connect a single throttle cable to the carburetor throttle mechanism and coordinate throttle opening across the pair. Its external linkage arrangement provides the cable interface and adjustment points needed during installation and synchronization.
Correct linkage geometry is important for consistent throttle response and reliable fuel-system operation. A bent, worn, or incorrect linkage can prevent the throttle shafts from opening together, contribute to uneven carburetor synchronization, or interfere with full throttle and return-to-idle movement. Designed for dual-carburetor throttle control using a single throttle cable.
This sale is for the linkage assembly only. Dellorto carburetors are not included.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: LP2000.
Technical role: Top-mount single-cable linkage assembly for coordinating throttle operation on dual Dellorto 40, 45, or 48 DHLA carburetors.
Service relevance: Correct linkage geometry supports synchronized throttle-shaft movement, consistent response, full-throttle travel, and return to idle.
What Is Included
- Top-mount single-cable throttle linkage assembly for Dellorto 40/45/48 DHLA carburetors
- Linkage components required for the supplied assembly
Important Fitment Note
Verify the carburetor family and body-size marking before purchase: Dellorto DHLA 40, 45, or 48. Confirm that the LP2000 linkage geometry matches the top-mount arrangement on your carburetors, including the throttle-shaft lever interface, single cable-stop and adjuster position, cable-end seating, and available mounting points. Check any fastener and threaded interfaces against the existing installation, then compare the supplied linkage with the removed part before fitting.
Compare the removed linkage carefully; similar DHLA applications can use different cable and lever geometry.
This linkage can be used with dual carburetors operated by a single throttle cable, but exact suitability depends on the carburetor configuration and existing throttle-cable layout. Carburetors are not included.
What you see is what you get
Show all parts