Front Inspection COVER NEW for WEBER 48/50/55 DCO/SP
$ 7.6
Part number: ST4311
Made in: EU
Front Inspection Cover New for Weber 48/50/55 DCO/SP
This front inspection cover is used on Weber DCO/SP carburetors in 48, 50, and 55 configurations. It closes the front inspection opening and protects the carburetor interior from exposure during normal service. A missing, damaged, or corroded cover can leave the inspection area open and compromise the original condition of the carburetor body.
MPN ST4311 identifies this replacement cover. It is a service and protection component rather than a metering part, so it does not alter the main circuit, progression, enrichment, emulsion, fuel level control, or transient response. The pictured cover has an elongated profile with rounded ends and two mounting holes for attachment to the carburetor body.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: ST4311.
Technical role: Front inspection cover for Weber 48/50/55 DCO/SP carburetors, enclosing the inspection opening without affecting fuel metering.
Service relevance: Replaces a missing, damaged, or corroded cover to protect the carburetor interior and restore the original enclosure.
What Is Included
- One new front inspection cover, MPN ST4311
- Made in EU.
Important Fitment Note
This cover is intended for Weber DCO/SP carburetors identified as 48, 50, or 55. Before ordering, verify the carburetor family and confirm the DCO/SP code or marking. Compare the two-hole mounting layout, hole spacing, cover length and width, rounded end profile, and contact interface with the removed cover or the opening on the carburetor body.
Verify the mounting geometry and any required gasket or seating arrangement before installation; the cover is supplied without additional components unless specifically included above.
What you see is what you get
Show all parts
