6x Velocity Stacks air horn pipe trumpet slide in WEBER 45 DCOE
$ 201.3
Part number: 52840.001
Manufacturer: FAJS
Compatible with:
Family: WEBER
Family: DCOE
45 DCOE 13-13T - pn: 52840.001 (2 pcs)
6x Velocity Stacks Air Horn Pipe Trumpet Slide-In for Weber 45 DCOE
These slide-in air horns mount at the inlet of Weber 45 DCOE carburetors to provide a shaped entry for incoming air. The trumpet profile helps guide airflow into the carburetor throat and can influence induction noise, high-rpm breathing, and transient response compared with an unextended or damaged inlet.
For Weber 45 DCOE carburetors only—not for Weber 40 DCOE. The air horns do not replace main-circuit calibration, emulsion-tube selection, or fuel-level control. Correct carburetor synchronization, jetting, and inlet clearance remain important when servicing or tuning the complete fuel system.
Each air horn has a total length of 100 mm (4 in), with approximately 62 mm (2 1/2 in) extending visibly beyond the carburetor entry. The stated dimensions are 48 mm outside diameter, 46 mm inside diameter, 50 mm ring diameter, and 65 mm diameter at the enlarged trumpet end. The construction is steel with a chrome finish. MPN: 52840.001.
This replacement part is suitable for carburetor service and restoration work where the original component is worn, damaged, or missing.
Reference/MPN: 52840.001.
Technical role: Six slide-in steel velocity stacks provide a shaped air entry for Weber 45 DCOE carburetor inlets.
Service relevance: The 100 mm chrome-finished air horns support inlet renewal while carburetor synchronization, jetting, and fuel-level settings remain separate service requirements.
What Is Included
- Six slide-in air horns for Weber 45 DCOE carburetors
Important Fitment Note
Verify the carburetor family before ordering: these air horns are intended for Weber 45 DCOE units and are not intended for Weber 40 DCOE carburetors. Check the carburetor code or marking, the slide-in inlet geometry, the bore and ring interface, and the retaining arrangement used by the existing setup. Compare the 48 mm outside diameter, 46 mm inside diameter, 50 mm ring diameter, 65 mm enlarged-end diameter, and 100 mm overall length with the removed air horn or carburetor inlet.
Confirm the interface and clearance against the removed part before installation, especially where filters, velocity-stack screens, or adjacent components are fitted.
What you see is what you get
Show all parts